Elegoo Neptune 3 Pro, Plus and Max - Minimalistic Cable Management Mod

Since my first print with my Elegoo Neptune 3 Max I was extremely disapointed with the cable management. Especially the fact that the cable to the extruder hangs down and hits the print/bed. I made this mod so I wouldn't have to add a cable chaing but instead tried to use the built in one-way-stiff-structure of the flat cable. Note: When folding the cable over, be very careful to leave a nice curvature so you do not damage it.

• The Extruder part replaces the original metal plate. You can use the two original screws to attach the new part.
• The Z-axis part replaces the small plastic clip that holds the cable to the Z-axis. You can use the original screw to fasten the new part
• The Base part replaces the plastic clip that snaps into the bottom/base frame. The new part should snap into place in a similar way as the original part.