Bottle dryer stand for SodaStream bottles or thermoses

This model is divided into two parts, the bottle holder itself and a plate where the water can collect. The plate can be printed if necessary (I find it very useful).

The dry-stand can be used for SodaStream bottles and also for slim thermos bottles.

The top opening is 70mm in diameter and tapers to 60mm within 2cm. This fits a broad range of bottle shapes. 

I printed it in PLA+. PETG should be used if you want to clean the parts in the dishwasher.

For the stand, I took an infill of 25% and 4 wall loops. This gives the model a good weight and stability. Three wall loops may also be enough. The bottle stand must be printed upside down. No support is necessary.

For the plate, I took a circular pattern for all surfaces because it is perfectly round. This fits well to the part and the printing goes a little faster.

I would love it if you like it and would appreciate feedback and makes.