Superman (fanart)

This is a fairly quick print of Superman.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA BambuLab Basic Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #8 (0.72mm) swap to Charcoal Black
• At layer #10 (0.88mm) swap to Cement Gray
• At layer #14 (1.2mm) swap to Gray
• At layer #18 (1.52mm) swap to Light Gray
• At layer #24 (2mm) swap to Bone White
• At layer #27 (2.24mm) swap to White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.