Aeropress wall holder

This aeropress holder is designed with a slight snap-fit to hold the aeropress and some filters. 

I just glued it to my glass wall in my kitchen with double sided tape. One could add holes for screws if needed, that's why I shared the .step file. 

My goal was to make it easy to print and not use too much material. Added a hole to support the filter holder part with organic supports. 

For softer materials like PETG I would recommend either more walls or more infill for the snap-fit part, or else it might feel a bit too loose. 

My settings:

Printer: Prusa MK3S+

Filament: Polymaker PolyTerra PLA cotton white

12% rectilinear infill

Support enforcers “highlight overhang by angle = 42°” in PrusaSlicer. Which should result in a max. 48° unsupported overhangs. That way only the hole is used for organic supports as shown in screenshot. 

Otherwise used the standard settings in PrusaSlicer.