DeWalt compact leaf blower DCV100 angled air concentrator duct

I initially created this just to help angle the airflow from my DeWalt DCV100 blower to be horizontal to the ground rather than blowing the leaves & grass debris into the ground.

Not only did it help to push the stuff in the correct direction but to my surprise it also made a difference to the speed at which the debris was cleared!

It was designed to print with the round end onto the print surface. This round end is deliberately angled so that the part can be printed without support.

I would suggest printing in ABS or similar for ruggedness although I'm sure PLA will also be fine for most uses.

Print with a brim if you are worried about bed adhesion - it is a tall print!

From memory, I used 4 outer perimeters and 50% infill for strength.

Installation onto the blower is just a case of pushing it over the existing rubber end pipe.

Mine has been in use now for about 12 months and is clearly going to stand the test of time. I have since printed more for friends & family and they also love it.

It's one of my favorite DeWalt creations and makes leaf & grass blowing even more fun & productive!

If you like this model then please download & hit that heart-shaped button.