SKÅDIS Storage Basket / Cart / Bin (Large & Medium)

I needed multiple storage baskets and didn't really wanted to buy them from IKEA since they come in a pack of 3. I created this model to be as close as possible to the original, except it uses hexagons instead of the original diamond pattern. Even in PLA, the printed basket is strong enough for its purpose.

The top, middle, bottom and hooks are separate parts in the STL so you may print them in different colors, if desired.

❤ - Don't forget to like and share your makes!

Recommended Print Settings

• Orientation: Upside down
• Material: Any (PLA, PETG, ABS, etc.)
• Layer Height: 0.2
• Wall Count: 3
• Brim: Enabled. Try increasing the brim-object gap from 1 (default) to 1.12 so that brim can be removed easily.
• Support: Enforced sections only (use paint on supports as shown in the screenshots)
• Infill: 30% or higher. Optionally, you can split model to parts and have 100% infill for just the hooks.
• Seam Position: Aligned or Back

Changelog

1. 10/28/2023
   1. Significantly improved hooks. Keeps the storage basket snugly attached to the board.
   2. Added large version.
2. 10/27/2023
   1. Initial version