50mm tiny whoop

Here is my Mobula5, or Meteor50, or whatever you want to call it. Probably the smallest fully ducted whoop you can build. The frame design is based around the Mobula6 ducts to ensure very little airflow obstruction. Other whoop ducts can be used but may result in lower efficiency due to more obstruction

FC needs to be a plus style FC, and Camera needs to be a 12mm square Pinch camera or one of the clones. I am using a TBS unify nano VTX but many other VTX around 13-14mm wide should work too.

Motors can be any regular whoop motors. 0603, 0702, 0802, heck you could even try 1002s haha. The resulting build will be about 1g heavier than an equivalent tinywhoop due to the frame weight etc. My particular example weighs 21.5g. I am sure that with 0702s, reny screws and direct soldering it would be possible to go under 17-18g, but weight was not my goal here.

Its small, its cute, it flies pretty well.

Oh i forgot printing advice. PLA+, or ABS, or PETG for the frame, TPU for the canopy/battery holders. I printed my canopy with no supports. That seemed to work thanks to the stringyness of my printer/tpu. I also did one with supports and that was annoying to remove.