Elgato Facecam flip cover

Something that should've been included from the factory! This flip cover is designed to click in place of the fixed cover and does not obstruct the camera view when it's open even when fully zoomed out.

For assembly I've used a 3mm metal rod I had lying around as the hinge, although you could probably print one as well. It also accepts two 5x1mm magnets; these are optional if the hinge is not too loose or the camera isn't facing downwards.

The dimensions for the rod and magnets are contained in user parameters in the included Fusion 360 file if you want to change them! Note however that the magnet diameter dictates the size of the viewport, so you might end up obscuring the view.

Print Settings

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

10%

Filament: 

Generic PLA