Desk Mount Headphone and Controller Holder / Mount / Clamp

Sometimes you just need a little controller to go with your headset stand.

Parts :

• x1 - Body_front ( depending on the position of the mount, you might want to use Body_back. The only difference is the position of the controller)
• x1 - Bolt
• x1 - Bolt_head
• x1 - Left_arm
• x1 - Right_arm
• x2 - Snap_pin

If your table is too big for the Bolt_head to fit, use the provided Bolt_flat instead, it might not hold as well, but it'll do the job.

UPDATE 2019.01.07:

Due to popular demand (1 person asked) I've added longer arms (extended by 15mm)

Print Settings

Printer:

Anet A8

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25%

Notes:

The arms are at a weird angle and might seem they need support, but should print fine without any