Fantastic Canard - For Printing in - LW-PLA

Update:  I temporarily deleted some of the files for this project until I can verify the scale of each part.  I found a couple of parts that had somehow scaled down to less than 10% of their original size.  I can't expect people to try and work with that!

*************************************************************

So far, Fuselage Parts are done. Remember, many parts have duplicates on each side of the airplane. The wing has to be mirrored, because the plans only have the LH wing.

So I've taken the full sheet (Full Size) plans and printed them on my large-scale plotter just to make sure that my 3d-printed pieces match the plans. I'm not sure if it's possible to make all of the parts 3d-printed, but I think most of them could be, and if certain parts could be printed, it would make the airplane straighter, and hopefully it would have awesome flight characteristics.

I use Simplify 3d for LW-PLA, but any slicer should work if you have it tuned right!

Category: R/C Vehicles