Halloween Cauldron Candy Dish

This cauldron offers a choice of two optional lids, the cauldron lid or the witch's brew lid. Use the cauldron to hold individually wrapped candies, party favors or decorative items. Not intended for liquids or unwrapped foods.

Print the main part of the cauldron inverted as oriented in the STL file with organic or tree supports.

The surface of the brew was created with the assistance of Customizable Ripples OpenSCAD file. 

The bubbles are to be glued into recesses in the brew lid. There are tall, medium and low bubbles to choose from. Load the bubble file into your slicer and split it into individual objects then choose one bubble from each row by deleting the others. You should end up with one 24mm, one 18mm, two 16mm and four 12mm bubbles of whatever mixture of heights you like. Further separate them to print in colors you prefer The 24mm bubble has small ridges to make it easier to grip as a handle for the lid.

The black lid is flat on the bottom and doesn't fit over the "brew" while that is in place.

The cauldron pictured was printed on an AnkerMake M5 using AnkerMake PLA+ in black, "AnkerMake" green, red, yellow and orange and Flashforge purple PLA.

The overall size of the main part of the cauldron is approximately 6 ¼" (159mm) in diameter and 3 ¾" (95mm) high. Both lids can be slipped down into the cauldron for storage.

The cauldron is the same as the pot in my Leprechaun's Pot o' Gold and the inserts can be used interchangeably.