Standard Cable Clip for Microphone Stand

These cable clips fit your standard microphone stand. They support cables up to 9mm in diameter, the smallest clip only 7.5mm. The clips are super easy to print and come in three sizes:

• for 20mm/0,78inch (use the 18mm file)
• for 15mm/0.59inch (use the 13.5mm file)
• for 11mm/0.43inch (use the 9mm file)

Your standard microphone stand would require 20mm for the base and 15mm for the boom. The 11mm is only used in special dual-extension booms. I tired them out and they fit nicely on mine.

Print Settings

Printer:

CTC-3D (modified)

Rafts: 

Doesn't Matter

Supports:

Doesn't Matter

Infill: 

Honeycomb 3D at 30%

Filament: DasFilament PETG 
 

Notes:

3 outer shells, 30% Infill and 0.2mm layer height mimic the strength of the original clips I own. That obviously also depends on your printer and your printing material.

I only tried printing in PETG, but I see no problems in using PLA.

Post-Printing

Finishing

The edges might come out a little rough, especially if you have a little ghosting going on. File them down. If you got slight stringing, use a lighter and go over the stringed areas to melt the strings (don't be too slow or you'll danage your print).

Category: Audio