Broom holder (print in place)

I've printed a couple of them in two different sizes and worked very well! @fns720 it would be possible to see the "blueprint" to port the design to freecad? it would be super nice to be able to edit the sizes! Thanks!

Love this!

My mother-in-law was impressed.

My brooms are finally off the floor! These have a very satisfying "click" and are surprisingly sturdy. Great model!

https://www.printables.com/model/1689106-broom-holder isn't it just a steal of your design? (yes it is slightly different, but at least a shoutout should have been done) I even seen printables post that one on social media. That is sad, considering your version is older, and you have the source file.

Brilliant design, perfect for my application. Printed in PETG, it needed a little bit of persuasion to loosen up but fine now.

Good design works well

Amazing design, works perfectly... I ended up printing 12 of these in various sizes for my garage... very neat !! (edited)

Very simple print, but a major improvement for my cleaning closet! The tools sit tightly in the print so they can't fall out. Amazing.

EDIT: The broom holders keep falling off the wall after some time. I might have to try something else than double-sided tape to stick it to the wall.. (edited)

printed on PETG, made it with supports, was a bit hard to remove them from the tiny spaces but works perfect

Works perfect, nice and satisfying. No complaints.