Very nice! :D
Mickey Mouse Apple Watch stand
A cute Apple Watch stand, compatible USB-C chargers.
125
794
5
2884
updated
October 23, 2023
Makes
Comments
Printed ultra detail (.07 layer height), but the bottom of the ears in the back didn't print very smooth.. maybe support would've helped?
But the charger fit well without sanding
The bottom of the circle is a little bit too tight. I have the USB C cable but the small extra insulation makes it too tight.
I had to enlarge the hole for the USB plug to pass through because original model was sized for a USB type C. I also had to open up the bottom of the circle where the cable comes out of the charger because it was too tight. Otherwise printed great without supports. (edited)
@Behndthmask_160587 Does your charger have a USB-C cable or a USB-A cable? This model was made for the USB-C cable of a series 8 and 9.
@jedisct1 You are correct, I totally didn't think about that when I printed it. I went back and edited my original post.