2.5" to 3.5" SSD HDD Bay Adapter

Universal 2.5" SSD/HDD to 3.5" HDD bay adapter. 

• The adapter can be attached to the 3.5" bay using side and bottom screws
• Supports side rails
• Recommended to print in PETG
• No supports required
• V2 and V3 require no screws to attach the 2.5" drive to the adapter
• Aligns the 2.5" drive to the center - not suitable for enclosures that have a fixed SATA connector designed for 3.5" drives. For that purpose you can use https://www.printables.com/model/627541-25-hdd-to-35-nas-bay-adapter

Version 3 (Recommended)

The same as Version 2 it requires no screws, as the drive just clicks into the adapter and firmly stays there. This version also has chamfered bottom edges, so in some cases might be prone to warping. If that happens, try Version 2 instead.

No supports required.

Version 2

This version requires no screws to attach the drive to the adapter - it just clicks in place. This version is easier to make if your make of Version 3 tends to warp.

Requires no supports.

Version 1

Requires 4 standard motherboard/disk M3 screws with lens head to attach a drive to the adapter. The edges are filleted.

It will print fine without supports, but they can optionally be used just on baseplate (for the screw holes) and no supports for bridges.