Great model! I made it a bit wider and printed in PETG to see how it handled my big, heavy, steel office door. Works very well and is easy to release the door with a press on the top.
Kicky Door Stopper (Print in place)
A print in place easy doorstopper that you can kick to hold the door in place and press to release easily with no fuss.
In the contest Door Stoppers
171
922
7
6335
updated
October 25, 2023
Makes
Comments
Really good Job. I printed the model that is flat, but I've to use with a ceramic floor, so to improve the traction I've use hot glue in the base, and then when was cold It works perfect.
Thanks for sharing
Works great! Have to kick a little harder to fix it in place, which is concerning to me because it's PLA but I think it'll be durable enough that I don't have to print another doorstep even again because it's quite bulky and direction of the layer lines make it stronger.
I'll probably add rubber gaskets at the bottom if it ever starts to slip but I don't feel like it will, because of the wedges.
Thanks for saving my doors from slamming because of the wind!
Are there any instructions on how to attach this to the door? It looks so cool that I put two of these to print for 10 hours 😅.
Also, can it accomodate a 32mm thick door? And how much it needs between the door and the floor? (edited)
