Swamp Thing Neon - HUEFORGE

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

0-0.6mm is solid black no details, you can easily add a height range modifier to print 0-0.6mm in 0.2mm layer height to save time but be sure to add the changes at the correct heights because the layer numbers will change if you use a height modifier. 

Filaments Used:
PLA Creality Black Transmission Distance: 0.2
PLA AnyCubic Purple (Fucshia) Transmission Distance: 2.6
PLA AnyCubic Green Transmission Distance: 3
PLA Creality Value White Transmission Distance: 7.2

Swap Instructions:
Start with Black
At layer #10 (0.92mm) swap to Purple (Fucshia)
At layer #17 (1.48mm) swap to Green
At layer #25 (2.12mm) swap to White for the rest.

 The STEP file is NOT a step file. If you own HF feel free to customize or make any changes for your filament or even make it better. Rename .STEP to .HFP and you'll have my hueforge project on it. 

personal note: if I were to reprint it I would use a higher TD white or high TD yellow like sunlu meta yellow