Print-in-place jiggle skeleton

A 3D printed version of one of those jiggle skeletons you would find at a Dollar Store. (work in progress and any suggestions would be greatly appreciated) 

             Features 

• arms and legs have joints 
• around 6cm tall
• prints in place
• 0.2mm tolerance horizontally and 0.1mm tolerance vertically
• Mounting hole in head so you can attach it to whatever you want (e.g. keyring, necklace …)                                                                                                                                                                                                                                                                                                    Printing recommendations                                                                                                                              
• use ironing for best results 
• 10% infill should do 
• as of now you will need to use a smaller nozzle size than 0.4 other wise it will not work unless you print 200% size you have been warned (if you have a resin printer you will be fine)

(print the v3 it is better)