Magnetic door stop/holder

Hello,

this is my version of 2 piece magnetic doorstop.

Main body comes in 2 versions, 1 with guide and 1 without guide in case you have no clearance under your door. Main part was attached to the floor with strong double sided tape and I had quite hard time to remove it.

Piece for the door (smaller one) should be mounted with double sided tape. Side with little dot at the bottom should face the door because side without it is thinner and will create much better contact between the magnets.

Before you place the magnets, check their polarity, place the first magnet to the main piece a check the polarity, once done, add the magnet into door mount.

Magnets used for this project are 2 longer magnets from MK3s+ kit (i.e. 20*6*2mm).

Holes at the top of both pieces are for magnets removal with little help of allen key. Size of the holes is 1.7mm.

If you need some tweaks to fit your needs, use measure tool in Prusa slicer or contact me and I will adjust it of needed.

last step is to enjoy :) and do not forget to add a photo of your prints