Jack O'Lantern D20 spinner

Hi everyone!
I am glad to present to you my first design:
Jack O'Lantern d20 hallowen spinner.
It is quite easy way to introduce a little of atmosphere in to you RPG session!

Printer:
Ender 3 neo V2

Filament:
PLA:
-black
-green
-white - no orange sorry :(

Supports:
- On Pumpkin_Top - inside for two extrusions for pins and one for the mouth, 
- On Pumpkin_Bottom - Inside the Pumpkin, for the ring on the top.

Rafts:
No

Infill:
10%

Nozzle:
0,4 mm

Leyer hight:
0,2 mm

Parts to print:
1x Pumpkin_Bottom
1x Pumpkin_Top
1x Pin_Top
1x Pin_Mid
1x Pin_Bottom
2x Pumpkin_Pin

Other Parts:
1x Flat spring - 2x6x20mm 

Assemble:

After printing and cleaning each part place Pin_Bottom in the pentagonal hole in Disk, If it a liitle too loose you can use some glue. On the top side of Disk put narrow part of the Pin_Mid. 
Glue Spring in to the stand inside Pumpkin_Bottom. Place disk withe both pins inside Pumpik_Bottom, be sure that the spring landed in the triangle holes on the Disk . In the holes on top of Pumpkin_Bottom place two Pumpkin_Pins. Close pumpkin using Pumpkin_Top and insert the Pin_Top from top through Pumpkin_Top and into Pin_Mid. 

Notes:
 If you can not see the numbers you can use silver sharpie to paint side of the disk to create some contrast between walls and numbers.

Designing this Pumpkin was a lot of fun for me. I hope it will be suited for you.
In case of some problems write a comment, I will try to help.

Have fun!
NF