Shadowfiend

Shadowfiend, a creature of the darkest depths, thrives on the souls of the fallen. With each soul consumed, its power grows, casting fear into the hearts of enemies.

This is a fairly quick print, use 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA PolyTerra Charcoal Black
• PLA Overture Cement Gray
• PLA+ Sunlu Gray
• PLA Overture Light Gray
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #7 (0.64mm) swap to Charcoal Black
• At layer #10 (0.88mm) swap to Cement Gray
• At layer #14 (1.2mm) swap to Gray
• At layer #17 (1.44mm) swap to Light Gray
• At layer #19 (1.6mm) swap to Bone White
• At layer #21 (1.76mm) swap to White for the rest.

Enjoy my work? Support me by joining my club. Tier 1 offers exclusive models, while Tier 2 allows you to sell my 3D printed artwork.