Ferris Sweep case and 10° tenting stand with 8mm diameter rubber feets

After making my sweep bling low profile with choc 1s, I couldn't decide whether I'm going with no case at all, with only the case, or with a stand. So I tried them all, each with their own rubber feets attached. This does make the whole thing taller and thicker, but now I can choose to type however I want, with or without cases or stands.

If you want the case to be at different angles, well… I tried 30~10°, 10° works best for me. I have STLs of 30 and 20°, but all without holes and acts like small drums. Just draw with Fusion and use project on sketch and loft functions. The outcome will be more meaningful if made yourself, right? 😏

Remember to mirror it if you going for the other side.

I use rubber feets with 8mm diameter and 4mm height, so I cut some shallow holes for them to make the whole thing thinner. Normally the feet on the cases are in the way of the 10° stands at this angle, so I enlarged the feet models a bit and cut them.

Originally I just print one without any hole, and the whole keyboard acts like a drum. And I hollowed out the bottom, and it was even louder, so I gave it different holes in different directions. That fixed it.