Rubbermaid Reveal Cordless Battery Power Scrubber Stand

Created a custom holder for the Rubbermaid Reveal Cordless Battery Power Scrubber Home Kit (here). The clearance is a little sloppier than I would like but definitely usable. The main handle moves freely but doesn't rotate 180 degrees when in place. 

Printed with my Creality S1 Pro running Klipper inside a newly acquired Creality Enclosure. Sliced with PrusaSlicer. 

Putting all the info that I would want to see when finding a print that I want, hopefully this helps. If you make this and improve any of the flaws I point out, please let me know so I can improve my quality settings.

Print Settings:
0.2mm layer height
10% Support Cubic Infill
Creality EN-Black PLA at 210C
PEI Textured Bed at 60C
3 Vertical Shells
3 Top and Bottom Shells
Seam Position Rear (opposite side of slots for pads)
25 mm/s First Layer Speed
100 mm/s Perimeter Speed
35% to 70% Fan Speed

Comments:
Can see the infill pattern a bit when looking from above, may need to up the number of Top and Bottom Shells a bit. A little bit of a rough texture on the top surface, I think that may be over-extrusion but not certain.