Smaller diameter & Longer spool holder for raise3d N2 printers

Use

This spool holder allows to fit longer spools with smaller holes which did not fit on the original Raise3d N2 spool holder. 

Information

The long version fits spools of a length up to 10cm (~4in) and a diameter bigger than 4.5cm (~1.8in)

The short version allows for the same diameter, but only spools up to 7cm (~2,8in) (this is the average 1kg spool length and the same length as the original spool holder). Print this version if the only problem you have with the original spool holder for you is it's diameter as it allows to fully close the door. This version fits most spools. 

Print

• Use supports
• Better results using infill patern such as Gyroid (the part kept breaking using the grid patern) 

Note

If you print the long version you will NOT be able to fully close the side door; only the short version allows to do so. 

Feel free to modify the length/diameter to your needs using the FreeCAD files provided.