Weather-witch

Can be assembled without the use of glue

In addition to the 3D printed parts that must be used:

• 2 x M4x35mm, nut and washer. 
• 1 x Ø2 mm bicycle spokes in stainless steel (> 11cm). It may well be an old cracked spoke, as only the threaded end must be used. 
• 1 pearl etc. to reduce the friction between pointer and top
• 1 x Ø16mm rod or pipe in suitable length
• 1 zip tie
• Around 20cm 1,5mm2 massive copper wire, etc. to hold the parts together.

To reduce the friction between pointer and top, a pearl or other is inserted

A bicycle spoke is used as the vertical axis. The axis must be approx. 85 mm, plus height of the pearl. The axle/spoke is bent 90° to the horizontal. The horizontal pieces must be approx. 20 mm to fit in to the Branch A 

Wind vane with a picture of a witch is fixed with a zip tie. By not gluing it, it can be changed to another image

The other parts are attached with solid electric wire, steel wire, nails etc.