Pop up Ghost

The idea for this came about because I have recently been doing Kinematics in University, the idea is that you can have a ghost that pops out from behind a grave. 

Below is the very simple assembly for this decoration:

First, you put the two pivot arms into the base of the ghost.

You then take two of the C-clips which simply snap onto the pivot points as can be seen below.

You then place this sub assembly on the back of the gravestone and clip it onto the back using the last two C-clips.

Once you have done this, the model is complete so you are now able to use it. However, as an optional extra, you can use loom bands or any other small elastic band to keep the ghost from falling down once it has been popped up. these bands will still allow you to lower the ghost so that it cant be seen.

This is done as follows

Thank you for taking the time to look at this model, I hope you like it! If there are any alterations or parts you'd like me to design for this model, just send me a message. 

(this model will continue to get updated)