The Cat Doorstop

The Cat Doorstop 

Just a cat that sits and holds your door in place.

Use the following settings for a good strong print

• Layer Height = 0.2 to 0.28
• Walls = 4
• Infil = 35%
• Wall Generator = Arachne 

Stick some ducktape on the bottom to keep it from sliding on tile / smooth surfaces.

Cater for a floor to door gap of 17mm / 0.7 inches.

If you enjoy the make or find it useful, please share your make and drop a like.

Want to sell 3d prints of this model commercially? Sign up on my Patreon page. 

Also check my other models on https://makerworld.com/en/@MattZA