Sands of Time

Unique filament painting that depicts the Sands of Time.

This painting is composed of two parts, the upper and the lower and has it's own wall mount system to hang it to the wall.

As always, looking forward for your prints and comments :)

Both parts, have the same layer changes and you need to print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

• PLA Overture Black
• PLA Overture Chocolate Matte
• PLA Overture Chocolate
• PLA Overture Brown
• PLA PolyTerra Peanut
• PLA+ Esun Bone White
• PLA Overture White

Swap Instructions:

• Start with Black
• At layer #8 (0.72mm) swap to Chocolate Matte
• At layer #13 (1.12mm) swap to Chocolate
• At layer #16 (1.36mm) swap to Brown
• At layer #20 (1.68mm) swap to Peanut
• At layer #24 (2mm) swap to Bone White
• At layer #28 (2.32mm) swap to White for the rest.

For the wall-mount piece, you can print it with 0.20 layer height and 20% infill.
As shown in the picture, you place 2 sided tape on the orange painted parts (feel free to add more) and make sure the mount is on the top. After that just place the two parts so the are aligned on the centre.