Aqara G4 Halloween Pumpkin decoration

Edit: took the 1 minute extra to make a “nofront” version, the initial model may disrupt the night vision

Wanted to make a surprise to my kids when they come back from school, so quickly "merged" two models to decorate my Aqara G4 Doorbell into an Halloween themed one.

Only used PrusaSlicer and the two referenced models to quickly get something functional.

Paired it wit a custom doorbell ringtone and did the trick

Printed it only once (photo above):

• MK3S+
• PETG
• 15% infill, but I suspect would work without (not tested)

Only used PrusaSlicer to remix/merge the two original models

Took the nice fitting Aqara G4 Doorbell Cover and remade the holes for the camera and sensor.

Took the scary looking pumpkin coaster and removed the base to keep the cutout part.

Merged the two and voilà!

Lots of improvements are possible (like probably fully removing the front plate et only keeping the contour circle to attach to the doorbell, current cutout is visible in the corner of the video feed) but I needed it last minute so good enough for me in this state