Suspended Jack-O-Lantern Light

This suspended jack-o-lantern comes with a slot in the back so you can insert a 1.5in diameter tea light inside so that you have that classic night time look!

simply slide the tea light in and gently place the cover over the opening.

• print in 0.2mm layer height
• no supports needed!
• make sure gaps between suspension lines and main body do not fuse!
• may need to activate print thin walls option if lines do not appear.
• make sure infill is at least 20% so that the line mounts do not fail.

I used some standard 1.5in dia x 1.4in ht tea lights (orange colored for extra blending in)

be extra careful when removing from build plate as inside and outside portions are only connected by thin lines which could break if both portions do not come off at the same time!