SRAM 2 CHAIN GAP TOOL

Perfect thank you :-)

Did it "quick and dirty" with new pla without calibration.
Comes out great.
Remove the Supports was harder than expected

The design prints relatively well.
The only thing I would test to see if it will help improve the print quality at no expense to the strength is to print the various overhanging features separately and glue them together. This is to avoid the supports that are needed with this design.
Thank you for sharing this.

Comes in handy!

Perfect fit on my SRAM SX. Thank you very much! :)

Works really well on my SRAM SX! Printed with a Flying Bear Ghost 5 with PLA at 200°.

Printed great in PLA. I used organic supports in Prusa Slicer 2.6, they were a little tricky to remove but came out easy enough.

Thanks for the design :-)

As my Gap Tool was broken (see picture), and I didn't want to spend 10EUR on a new one, I gave this model a try.

The support was relatively easy to get away with forceps.

Tomorrow I will test it on my bike.

Thank u! Printed well, just removing the support is a bit of a hassle, but possible.

Un grazie di cuore per l'ottimo lavoro, un aiuto veramente fattivo.
Grazie!! (edited)

great work! Is it made for 10-50 cassettes or 10-52?