This is an easily printable sprinkler system for your garden. You can snap your sprinkler on the stick and you can stick it into the soil. You can conect the sprinklers with ½" hose.
Update 2021.04.02:
I have added a new type of sprinkler to the collection, and a T element to create multiple lines. I also added a rib inside the sprinklers, for the easier print.
Use version one for lower range us such as flower bads and vegetables, and the new version 2 for higher and wider range.
I printed it with 0,3 mm layerheight, and turned on the thin wall features.
Update 2021.04.05:
Based on feedback, I redesigned the sprinkler parts, and now you can print them without support. I lovered the conector parts, and redesigned the ceiling. The T conector can be printed on the flat side also without supports. I also made the stick printable without support, it lays on one flat side, but because of the steep rise, it prints the bottom side in the air. It is ugly and the clips can be weaker and brake at layer lines so I recomend to print it upside down with minimal support. I also made a shorter 80mm stick if you don't need a longer one. The new print orientation is shown in the gallery.
Autor nie podał jeszcze pochodzenia modelu.
