PVC Pipe Tripod (¾" ID)

Sometimes you just need a stable vertical piece of PCV when you're making a project. A tripod gives you a nice combination of stability and efficient use of space. And you won't find this in your local big box store since it's a horrible design for actual plumbing.

Print tripod and 3 feet in the same orientation you'll use them, no supports required. I used .3mm layer heights and PETG for faster prints and more outdoor durability, should be fine in PLA.

For extra stability fill the tripod with sand or gravel, that's why the bottom of the feet are sealed off.

(Note: my photo shows the feet cut off at the top, had a print failure and was too lazy to reprint, the files have a complete foot.)