[Fusion360] Scalable parametric Hinge

This is a Scalable Hinge designed in Fusion360, i'm new to 3D Modeling and printing, i needed a hinge for one of my designs and lost a lot of time redrawing the Hinge to fit my needs. so i designed this simple scalable hinge, it took me more than 20 hours to get to this version.

Parameters:
- Length: length of the leafs
- Width: width of the leafs
- Height:  (Height of the complete hinge (the pin diameter and barrel scales with height)
- Tol: Tolerance between basic movable parts
- TolPin: Tolerance between pin and barrel 
- TolBarrel: Tolerance between barrel and Joint 
- Angle: Angle of the right leaf (-90 to + 90)
- MaxBridge: set to desired bridge length. this must be lower than the maximum bridge you can print, (if you print at an angle, set this lower)


please leave a like or a comment, this is my first design, im very proud of it. 

Smallest settings ive tried on BambuLab P1S With BambuLab PLA

height: 2.5mm (Works Flawlessly) Havent tried smaller
tol: 0.4 (0.3 is a little too tight)
tolpin 0.4
TolBarrel: 0.2 feels good enough. 
max Bridge ive always kept as low as possible. long bridges are a weak point

V2.0 Changes

• fixed some bugs
• maximum quantity of hinges is now 250
• removed logo completely (created more problems than anything else)
• added radius to pin adhesion to the joint for extra strength