XTool F1 - Base Plate Jig - 1 x 100mm Round (3MF and PDF)

Description

Base plate jigs replace the metal base plate in your XTool F1 machine. Simple pop out the original base plate and drop in the new base plate. All base plate jigs allow you to focus your laser as you normally would, just make sure to have a blank in the centre of the jig. The included PDF drawing includes a centre mark for you to design your XCS or LightBurn templates around. The same drawing can be used for both the A and B variants. 

Package contents

The quality and fit of the final product may vary depending on the printer, settings and filament you use:

• All 3MF file names ending with A are designed to exact dimensions and are recommended only if your filament does not shrink.
• All 3MF file names ending with B are over-dimensioned with 0.5mm to ensure your blanks will fit, even if your filament shrinks a little bit. 

Manufacturing

Start with importing the 3MF file into your favourite slicing software. The print settings are not critical but here are the settings I used:

• Layer height: 0.20mm
• No supports
• Wall loops: 2
• Infill: 15%, grid