Two-colored Hubelino-Lift Components

As a remix this THING uses the original version but provides two-coloured versions of

the 3 large components of the tower.

Print Settings

Printer Brand:

Ultimaker

Printer:

Ultimaker 3

Rafts:

Yes

Supports:

Yes

Resolution:

0.4 x 0.15

Infill:

20%

Filament: Ultrafuse PLA misc

Notes:

add the two components of one part, rnassign those parts to the two different extruders,rnthen select BOTH together, right click and select MERGE to combine them to one component again.rnrnBackground: Both components are exported from the same assembly, so they do share the same coordinate system or origin.

Use Raft and Support.

I had a lot of issues with warping, probably because of the thin walls at the bottom. So going with rafts should prevent the warping. And because the Support is required anyway for the geometry below the floor, it does not hurt.rnrn

Rafts and Support.

removed supports.