Raspicam case for Ultimaker printers (Ultimaker 2/2+/extended,...)

Two parts case for adding a Raspicam (for Octoprint or Klipper, or anything else...) to an Ultimaker 2/2+/extended. (Should be compatible with other Ultimaker printers, except if there is already a cam at the same place ;-) ).

BOM : 1x M3x8 screw + strong double side adhesive tape (for the two contact faces of the case with the enclosure walls, and for supporting the Picam ribbon cable onto the ceiling).

Printed in HD PLA with 0.1 mm layers, with no support.

See pictures for more details.
(Note the case was not yet glued to the two walls in the first picture, but it allows visualizing its mount and where the ribbon path is... if you zoom in a little bit).

No raft; layer height : 0.1 mm; infill 30%, walls 2 or 3; One support is already inside the rear case design with a 0.15 mm gap.