QUICK-CLIP : Locking Pin Storage Tree

NOTE: This is an add-on to the pre-existing "QUICK-CLIP : Base Starter Kit"

Post-Processing Difficulty: Easy (Ready to Use from Printer)

Tools Needed: None

Introduction & Instructions:

QUICK-CLIP is a versatile mounting system that I designed for backpack and MOLLE webbing. This is an add-on storage organizer designed to keep your unused locking pins secure while your modules are detached. It can also be use to store extra locking pins, in case you lose one.  There are five different versions available, each being able to store sequentially more locking pins, up to five maximum. 

The standard locking pin (orange) files are available in the base starter set. 

I printed these with 0.16mm layer lines with PLA with no supports or brims. 

IMPORTANT NOTE: This was designed to have a slightly tighter fit than with the standard clips. If you'd like a looser fit, just scale/increase the length of the model in your slicer by 1%+ These print fairly quickly, so you can test which fitment it right for your needs.

Hope you enjoy!