6cm Pot 3 x 3 Holder and tray

Designed to fit on a Prusa mk3 and hold nine 6cm cardboard seedling pots. 

UPDATED 17/04/21 with pot to fit 0.8mm thick

UPDATED 18/04/21 at last I have got to grips with the vase setting on the PrusaSlicer new pot stl added. 

You can see I have left 1mm ish gap when holder is sat in the base.

I also had a go at printing a 6cm pot with varying success using and not using the Vase setting. The pot has a push out bottom. I do not have a good understanding of this Vase setting yet so had to go back to normal print settings.

I used up some old generic wood filament on a draft setting 215c nozzle and 60c base. Came out ok I think. Later prints now with Sunlu plus black. Delivery options for Pursament still far to high. 

Designed as said on Fusion 360, Sliced using PrusaSlicer, used Octoprint to upload to printer with an arc welder setting active