Fallout 4 - Baseball Grenade

Very easy to print, only the bottom part needs support where the baseball has contact.
 

Print in PLA at 0,15mm layer height and 5 walls, 30% infill.
The base can be printed at 0,15-0,2mm, 3 walls and 18% infill.

You need an 8mm drill for this into the baseball, where you then glue the bottom part in and on.
Regular superglue is enough for this. Be sure to hit the center on top of the baseball, but who cares, its fallout, nothing is perfect at a wasteland product!
You also need to glue the top to the bottom!

Also you need a wire with 0,9-1mm diameter and a keyring (black prefered).
Put the wire into the keyring, the ends then come into the powerdrill, where you use this to wind the wire up lightly.

Cut it to the length you want and put it trough the little 2mm hole, bend it to side afterwards at the end a little so it dont come out on itself.

After that you can weather it.
I used regular vallejo acryl colors and washes for this plus some rust effects for the primer on top.