Anova air intake

This is a cool air intake for the anova BT to hopefully avoid drawing in warm wet air from the pot into the electronics. In a few preliminary tests it seems to help avoid condensation and provide cooler, drier air to the intake, but I can't guarantee it's actually going to help with anything...

As with anything like this, you might end up doing more harm to your device than just leaving it alone, so use at your own risk.

Post-Printing

The "split for print" and "tube" files are designed to be printed (reasonably well) without supports.

Needs to be glued or welded together after printing. Be sure to keep the portion that sits against the anova smooth to seal as well as possible. needs two normal size or smaller zip ties to complete.

Be sure when you are using this that the tube tilts down and away from the anova so it doesn't drain INTO the cooker if water does pool in the tube. I added a few degrees of slope to help with this, but YMMV depending on how you use your cooker.