Pixel 8 Pro Case - Remix with Cutouts

I wanted to save a bit of material, so I added a few cutout areas on the back, which then can be used to display wallpaper etc for a bit of extra personalisation.  

Tinkercad wouldn't load the model as it said it was too complex, so I used blender.

I did get a few cracking issues when finishing it up, and fixed most with a soldering iron.  There's an issue with a crack in the top left at weak spot that I'm not sure what can be done about, but it doesn't seem to functionally matter.  

Thanks to everyone involved in making this, just thought I'd post as remix in case (no pun intended) someone else wanted to use it.

Printed in PETG 

 

Added some cutouts to allow a bit of personalization and reduce material use.