Glowing Ghosts Tea Light Plug

I really like the Glowing Ghosts Spooky Ghost, but wanted the tea light to fit snugly so that when my kids moved the ghost, the tea lights followed it.

This locks the tea lights I purchased snugly into the plug. The plug then has a friction fit with the original Spooky Ghost that wont fall out when lifted.  It is also easy to remove by gripping the tapered edge and pulling down.  There is a cutout on the bottom so that you can turn the tea lights on and off.

Tea Lights (non-affiliate link): https://www.amazon.com/dp/B09KZS6M1L

The diameter of these tea lights is 36.5mm. Anything smaller would technically fit, albeit, loosely. YMMV on any tea light other than the ones I linked.

The print is only 3.5g and took 7.5 mins to print on my Bambu Lab X1C.

EDIT 8/5/24:

• Added two new models with slightly looser tolerances on the inner diameter at account for variables in manufacturing of tea lights:
  • Spooky_Ghost_Tea_Light_Plug_Loose relieves inner diameter tolerance by 0.1mm
  • Spooky_Ghost_Tea_Light_Plug_Loosest relieves inner diameter tolerance by 0.25mm

This is an addition to enhance the original model by holding the tea light snugly in the model.