Frog Postage Stamp Dispenser

This print is a remix of a frog sculpture I found here:

https://www.myminifactory.com/object/3d-print-frog-sculpture-3d-scan-59240

I scaled the original by 50%, and created an opening in the inside to hold a postage stamp roll, with an additional opening to dispense the stamps through the “mouth.” In addition, I made a simple cover for the bottom opening to hold the stamp roll in place.

To use the dispenser, insert a roll of stamps in the bottom, taking care to make sure the end of the roll extends into the mouth slot. Squeeze the side tabs on the bottom cover slightly, and push the cover into place.

To dispense stamps simply pull them out of the mouth slot and take as many as you need. Tear off any left over backing.

The OnShape 3D CAD file for the cover pieces is here:

https://cad.onshape.com/documents/4d768f66c4a9af7058378010/w/368d9d103b2a4579b2ccffde/e/b286ea9346e3efee17de69cc

Print Instructions

There are two parts to this print: The frog and bottom cover.

Print in PLA using the 3mf files provided.  No infill, brim, or supports are needed for either of the pieces.