Double Business Card + Name Plaque Holder

Some of my tinkercad tinkering. This is a card holder I made. There's two spots for business cards and a spot in the middle for a name plate. One model has the name placard part lifted so it's nearer to the top of the average business card height. A fun unique print for the office. Take just under 2hours on a prusa using the 30mm draft mode. 20mm will be about 3hrs or so.

Placard size:

100-113mm length
80-100mm height
1.5-2mm thickness

Square that is there isn't the correct size, i just stuck it there so people could see how  the design works.