Wyze 5070 Wall Mount

Mounts to the wall using 4 "Poster Strip" sized command strips on each bracket and an optional nail through each mount. 

To mount you will need

• 2 Printed Mounts
• 8 "Poster Strip" Command Strips 
• 1 M3 screw of at least 16mm 
• 2 M3 Nuts
• 1 M3 Washer

Instructions

1. Force the one M3 nut into the indentation on the top of the mount
2. Thread the M3 Screw in so that the head is facing up
3. Tighten down the washer and other M3 nut on the bottom of the mount, locking the Screw head at the proper height to catch into the bottom of the 5070 case
4. Apply command strips 
5. Stick to the wall
6. [Optional] Hammer in a nail through the hole

This Mount only interfaces with the centered screw slot towards the front of the case, the second mount in the back doesn't need a screw and is only there for bearing the weight