Kickstand Replacement for iPad Cases

Problem

The most common iPad kickstand case design found on Amazon was not designed to be durable. The tab which keeps the kickstand engaged is very flimsy. Even under normal use this tab is likely to break off after very few uses. The original designers tell you that you need to throw away the whole case and buy another one, but I changed that.

Design improvements

This replacement design puts the kickstand prop tab on the inner plate of the case, allowing the tab to be thicker, reducing the likelihood of failure. The tab is still thin enough to easily engage and disengage the kickstand.

Installation instructions

1. Remove your iPad from the case and disassemble the case
2. Clip off any remnants of the original kickstand tab from the kickstand's outer plate
3. Remove the original inner plate from the case
4. Screw the new replacement plate into the case

NOTE: the screw holes on this replacement do not come pre-tapped. Make sure to apply a good amount of pressure to avoid stripping the screws as you are screwing in this part. Also, beware of cross-threading! 

Case compatibility

Tested & confirmed compatible cases

1. Astra Cases Falcon Heavy Duty iPad Case
2. (Leave a comment with a link to your case if this part fits your iPad case and I add it to this list!)

Unconfirmed cases

1. Herize iPad Pro 12.9 Case 6th/5th/4th Generation (assumed compatible based on identical design)

NOTE: many other iPad cases on Amazon use this identical design, not just the one listed here. If you don't see your model here, try printing it before you throw out your case!

Print instructions

(Tested on Bambu P1S)

• I used PLA. I believe most materials should work
• Supports only needed for the tab