Staple Remover Replacement Handles

Hello,

Here are some easy to print replacement handles for some cheap staple remover. 

Print them out of PETG (PLA is also fine, but not as durable), at your preferred layer height with 4 perimeters. Print 1x Up and 1x Down.

Once printed, remove the rivets that were holding the original handles, install the new handles and then use a screw driver with a heatgun or anything else hot in order to melt the little tabs and the press them as flat as possible (See 4th picture if needed). Be careful not to burn yourself as the staple remover metal may become hot very fast!