Carmageddon Red Eagle

This car is based on a 3D model from Carmageddon (1997) and https://www.thingiverse.com/thing:2886047. But all parts are recreated from scratch.

Errata

• Bumper connectors are too thick comparing to the holes. Front and rear bumpers. The holes have an inside angle down. All solved by little work with a knife.
• A hanging part over the windshield is 1 layer thin. Just be careful.
• The windshield can be thicker to fight against overhanging. It was printed with semitransparent PETG - bottom layers not sticking to each other really well. May survive only a few installations.