This model is a modified version of @Peter_260424 Fan Shroud which gives a bit more clearance for the heater block, adds a cut out for the BLTouch(Though I'm using a CRTouch) cabling and attaches it to the main body to give it more stability. Additionally I added an ADXL345 mount on top. Finally, I also shored up the fan bolt hole as i broke that on my first install.
This was designed around an original ender 3 with a linear rail x carriage.
Probe Offset: X-35mm Y-8mm Z≈2.2mm (taken from @Peter_260424 description)
Printed on a Bambu Labs X1 Carbon (Maybe a bit sacrilegious) with overture ABS using orca slicers generic ABS settings. PETG would likely be sufficient.
The author remixed this model.
This model is a modified version of @Peter_260424 Fan Shroud which gives a bit more clearance for the heatblock, adds a cut out for the bltouch cabling and attaches it to the main body to give it more stability. Additionally I added an ADXL345 mount on top. Finally, I also shored up the fan bolt hole as I broke that on my first install